| apparent power | 1.6 kVA at 380 V | |
|---|
| prospective line Isc | 5 kA | |
|---|
| continuous output current | 2.2 A at 380 V2.2 A at 460 V | |
|---|
| maximum transient current | 2.4 A for 60 s | |
|---|
| speed drive output frequency | 0.5…200 Hz | |
|---|
| nominal switching frequency | 12 kHz | |
|---|
| switching frequency | 6...16 kHz adjustable12...16 kHz with derating factor | |
|---|
| speed range | 1…10 | |
|---|
| speed accuracy | +/- 10 % of nominal slip 0.2 Tn to Tn | |
|---|
| torque accuracy | +/- 15 % | |
|---|
| transient overtorque | 120 % of nominal motor torque +/- 10 % for 60 s | |
|---|
| asynchronous motor control profile | Voltage/frequency ratio, automatic IR compensation (U/f + automatic Uo)Voltage/frequency ratio - Energy Saving, quadratic U/fVoltage/frequency ratio, 2 pointsFlux vector control without sensor, standardVoltage/frequency ratio, 5 points | |
|---|
| regulation loop | Adjustable PI regulator | |
|---|
| motor slip compensation | Not available in voltage/frequency ratio motor controlAutomatic whatever the loadAdjustable | |
|---|
| local signalling | 1 LED (red)DC bus energized: | |
|---|
| output voltage | <= power supply voltage | |
|---|
| isolation | Electrical between power and control | |
|---|
| type of cable | Without mounting kit: 1 wire(s)IEC cable at 45 °C, copper 90 °C / XLPE/EPRWithout mounting kit: 1 wire(s)IEC cable at 45 °C, copper 70 °C / PVCWith UL Type 1 kit: 3 wire(s)UL 508 cable at 40 °C, copper 75 °C / PVC | |
|---|
| electrical connection | VIA, VIB, FM, FLA, FLB, FLC, RY, RC, F, R, RES: terminal 2.5 mm² / AWG 14L1/R, L2/S, L3/T: terminal 6 mm² / AWG 10 | |
|---|
| tightening torque | 1.3 N.m, 11.5 lb.in (L1/R, L2/S, L3/T)0.6 N.m (VIA, VIB, FM, FLA, FLB, FLC, RY, RC, F, R, RES) | |
|---|
| supply | Internal supply for reference potentiometer (1 to 10 kOhm): 10.5 V DC +/- 5 %, <10 A, protection type: overload and short-circuit protectionInternal supply: 24 V DC (21…27 V), <200 A, protection type: overload and short-circuit protection | |
|---|
| analogue input number | 2 | |
|---|
| analogue input type | VIA switch-configurable voltage: 0...10 V DC 24 V max, impedance: 30000 Ohm, resolution 10 bitsVIB configurable voltage: 0...10 V DC 24 V max, impedance: 30000 Ohm, resolution 10 bitsVIB configurable PTC probe: 0...6 probes, impedance: 1500 OhmVIA switch-configurable current: 0...20 mA, impedance: 250 Ohm, resolution 10 bits | |
|---|
| sampling duration | 2 ms +/- 0.5 ms F discrete2 ms +/- 0.5 ms R discrete2 ms +/- 0.5 ms RES discrete3.5 ms +/- 0.5 ms VIA analog22 ms +/- 0.5 ms VIB analog | |
|---|
| response time | FM 2 ms, tolerance +/- 0.5 ms for analog output(s)FLA, FLC 7 ms, tolerance +/- 0.5 ms for discrete output(s)FLB, FLC 7 ms, tolerance +/- 0.5 ms for discrete output(s)RY, RC 7 ms, tolerance +/- 0.5 ms for discrete output(s) | |
|---|
| accuracy | +/- 0.6 % (VIA) for a temperature variation 60 °C+/- 0.6 % (VIB) for a temperature variation 60 °C+/- 1 % (FM) for a temperature variation 60 °C | |
|---|
| linearity error | VIA: +/- 0.15 % of maximum value for inputVIB: +/- 0.15 % of maximum value for inputFM: +/- 0.2 % for output | |
|---|
| analogue output number | 1 | |
|---|
| analogue output type | FM switch-configurable voltage 0...10 V DC, impedance: 7620 Ohm, resolution 10 bitsFM switch-configurable current 0...20 mA, impedance: 970 Ohm, resolution 10 bits | |
|---|
| discrete output number | 2 | |
|---|
| discrete output type | Configurable relay logic: (FLA, FLC) NO - 100000 cyclesConfigurable relay logic: (FLB, FLC) NC - 100000 cyclesConfigurable relay logic: (RY, RC) NO - 100000 cycles | |
|---|
| minimum switching current | 3 mA at 24 V DC for configurable relay logic | |
|---|
| maximum switching current | 5 A at 250 V AC on resistive load - cos phi = 1 - L/R = 0 ms (FL, R)5 A at 30 V DC on resistive load - cos phi = 1 - L/R = 0 ms (FL, R)2 A at 250 V AC on inductive load - cos phi = 0.4 - L/R = 7 ms (FL, R)2 A at 30 V DC on inductive load - cos phi = 0.4 - L/R = 7 ms (FL, R) | |
|---|
| discrete input type | F programmable 24 V DC, with level 1 PLC, impedance: 4700 OhmR programmable 24 V DC, with level 1 PLC, impedance: 4700 OhmRES programmable 24 V DC, with level 1 PLC, impedance: 4700 Ohm | |
|---|
| discrete input logic | Positive logic (source) (F, R, RES), <= 5 V (state 0), >= 11 V (state 1)Negative logic (sink) (F, R, RES), >= 16 V (state 0), <= 10 V (state 1) | |
|---|
| acceleration and deceleration ramps | Automatic based on the loadLinear adjustable separately from 0.01 to 3200 s | |
|---|
| braking to standstill | By DC injection | |
|---|
| protection type | Overheating protection: driveThermal power stage: driveShort-circuit between motor phases: driveInput phase breaks: driveOvercurrent between output phases and earth: driveOvervoltages on the DC bus: driveBreak on the control circuit: driveAgainst exceeding limit speed: driveLine supply overvoltage and undervoltage: driveLine supply undervoltage: driveAgainst input phase loss: driveThermal protection: motorMotor phase break: motorWith PTC probes: motor | |
|---|
| dielectric strength | 3535 V DC between earth and power terminals5092 V DC between control and power terminals | |
|---|
| insulation resistance | >= 1 mOhm 500 V DC for 1 minute | |
|---|
| frequency resolution | Display unit: 0.1 HzAnalog input: 0.024/50 Hz | |
|---|
| communication port protocol | ModbusMETASYS N2APOGEE FLNLonWorksBACnet | |
|---|
| connector type | 1 open style1 RJ45 | |
|---|
| physical interface | 2-wire RS 485 | |
|---|
| transmission frame | RTU | |
|---|
| transmission rate | 9600 bps or 19200 bps | |
|---|
| data format | 8 bits, 1 stop, odd even or no configurable parity | |
|---|
| type of polarization | No impedance | |
|---|
| number of addresses | 1…247 | |
|---|
| communication service | Read device identification (43)Time out setting from 0.1 to 100 sWrite single register (06)Write multiple registers (16) 2 words maximumMonitoring inhibitableRead holding registers (03) 2 words maximum | |
|---|
| option card | Communication card for LonWorks | |
|---|
| operating position | Vertical +/- 10 degree | |
|---|
| width | 107 mm | |
|---|
| height | 143 mm | |
|---|
| depth | 150 mm | |
|---|
| net weight | 2 kg | |
|---|
| power dissipation in W | 55 W | |
|---|
| air flow | 19 m3/h | |
|---|
| functionality | Mid | |
|---|
| specific application | HVAC | |
|---|
| IP degree of protection | IP21 | |
|---|
| Variable speed drive application selection | Compressor for scroll Building - HVACFan Building - HVACPump Building - HVAC | |
|---|
| Motor power range AC-3 | 0.55…1 kW at 380…440 V 3 phases0.55…1 kW at 480…500 V 3 phases | |
|---|
| motor starter type | Variable speed drive | |
|---|