-
Elektrikaubad
- Tööstusautomaatika
- Kilbitarvikud
- Releed
- Klemmid
- Kontaktorid
- Mootorikaitse & juhtimine
- Kaitselülitid ja lahklülitid
- Liigpingepiirikud
- Pistikupesad
- Rikkevoolukaitsed
- Jaotusklemmide plokid
- Jaotuslatid
- Lati kated
- Nutikilpide seadmed
- Kombilülitid CB+RVK
- Sulavkaitsmed
- Kaablikanalid
- Hämaralülitid ja sensorid
- Sisseviigud & Läbiviigud
- Termostaadid
- Sojendid
- Kilbi jahutussüsteemid
- Kilbi LED-lambid
- DIN-liistud
- Dimmerid
- Teised Tarvikud
- Toiteallikad ja Mõõteseadmed
- Installatsioonitarvikud
- Juhtimine ja alarm
- Kilbid
- Teised kaubad
- Teenused
- Kontaktid
Details
Müüdavad tooted
| range of product | Altivar 12 | |
|---|---|---|
| product or component type | Variable speed drive | |
| product destination | Asynchronous motors | |
| product specific application | Simple machine | |
| assembly style | With heat sink | |
| component name | ATV12 | |
| quantity per set | Set of 14 | |
| EMC filter | Integrated | |
| built-in fan | Without | |
| network number of phases | 1 phase | |
| [Us] rated supply voltage | 200...240 V - 15...10 % | |
| motor power kW | 0,55 kW | |
| motor power hp | 0,75 hp | |
| communication port protocol | Modbus | |
| line current | 8 A 200 V6,7 A 240 V | |
| speed range | 1…20 | |
| transient overtorque | 150…170 % of nominal motor torque depending on drive rating and type of motor | |
| asynchronous motor control profile | Sensorless flux vector controlQuadratic voltage/frequency ratioVoltage/frequency ratio (V/f) | |
| IP degree of protection | IP20 without blanking plate on upper part | |
| noise level | 0 dB |
| supply frequency | 50/60 Hz +/- 5 % | |
|---|---|---|
| connector type | 1 RJ45 on front face)Modbus | |
| physical interface | 2-wire RS 485 Modbus | |
| transmission frame | RTU Modbus | |
| transmission rate | 4800 bit/s9600 bit/s19200 bit/s38400 bit/s | |
| number of addresses | 1…247 Modbus | |
| communication service | Read holding registers (03) 29 wordsWrite single register (06) 29 wordsWrite multiple registers (16) 27 wordsRead/write multiple registers (23) 4/4 wordsRead device identification (43) | |
| prospective line Isc | 1 kA | |
| continuous output current | 3,5 A 4 kHz | |
| maximum transient current | 5,3 A 60 s | |
| speed drive output frequency | 0,5…400 Hz | |
| nominal switching frequency | 4 kHz | |
| switching frequency | 2...16 kHz adjustable4...16 kHz with derating factor | |
| braking torque | Up to 70 % of nominal motor torque without braking resistor | |
| motor slip compensation | AdjustablePreset in factory | |
| output voltage | 200...240 V 3 phases | |
| electrical connection | Terminal 3.5 mm², AWG 12 L1, L2, L3, U, V, W, PA, PC) | |
| tightening torque | 0,8 N.m | |
| insulation | Electrical between power and control | |
| supply | Internal supply for reference potentiometer 5 V DC 4,75…5,25 V), <10 mA overload and short-circuit protectionInternal supply for logic inputs 24 V DC 20,4…28,8 V), <100 mA overload and short-circuit protection | |
| analogue input number | 1 | |
| analogue input type | Configurable current AI1 0...20 mA 250 OhmConfigurable voltage AI1 0...10 V 30 kOhmConfigurable voltage AI1 0...5 V 30 kOhm | |
| discrete input number | 4 | |
| discrete input type | Programmable LI1...LI4 24 V 18...30 V | |
| discrete input logic | Negative logic (sink), > 16 V, < 10 V 3.5 kOhmPositive logic (source), 0...< 5 V, > 11 V | |
| sampling duration | 20 ms +/- 1 ms logic input10 ms analogue input | |
| linearity error | +/- 0.3 % of maximum value analogue input | |
| analogue output number | 1 | |
| analogue output type | AO1 software-configurable voltage 0...10 V 470 Ohm 8 bitsAO1 software-configurable current 0...20 mA 800 Ohm 8 bits | |
| discrete output number | 2 | |
| discrete output type | Logic output LO+, LO-Protected relay output R1A, R1B, R1C 1 C/O | |
| minimum switching current | 5 mA 24 V DC logic relay | |
| maximum switching current | 2 A 250 V AC inductive cos phi = 0.4 L/R = 7 ms logic relay2 A 30 V DC inductive cos phi = 0.4 L/R = 7 ms logic relay3 A 250 V AC resistive cos phi = 1 L/R = 0 ms logic relay4 A 30 V DC resistive cos phi = 1 L/R = 0 ms logic relay | |
| acceleration and deceleration ramps | USLinear from 0 to 999.9 s | |
| braking to standstill | By DC injection, <30 s | |
| protection type | Line supply overvoltageLine supply undervoltageOvercurrent between output phases and earthOverheating protectionShort-circuit between motor phasesAgainst input phase loss in three-phaseThermal motor protection via the drive by continuous calculation of I²t | |
| frequency resolution | Analog input converter A/D, 10 bitsDisplay unit 0.1 Hz | |
| time constant | 20 ms +/- 1 ms for reference change | |
| marking | CE | |
| operating position | Vertical +/- 10 degree | |
| height | 143 mm | |
| width | 72 mm | |
| depth | 131,2 mm | |
| net weight | 0,8 kg | |
| Variable speed drive application selection | Commercial equipment MixerCommercial equipment Other applicationTextile Ironing | |
| motor starter type | Variable speed drive |
| electromagnetic compatibility | Electrical fast transient/burst immunity test level 4 EN/IEC 61000-4-4Electrostatic discharge immunity test level 3 EN/IEC 61000-4-2Immunity to conducted disturbances level 3 EN/IEC 61000-4-6Radiated radio-frequency electromagnetic field immunity test level 3 EN/IEC 61000-4-3Surge immunity test level 3 EN/IEC 61000-4-5Voltage dips and interruptions immunity test EN/IEC 61000-4-11 | |
|---|---|---|
| electromagnetic emission | Radiated emissions environment 1 category C2 EN/IEC 61800-3 2...16 kHz shielded motor cableConducted emissions with integrated EMC filter environment 1 category C1 EN/IEC 61800-3 2, 4, 8, 12 and 16 kHz shielded motor cable <5 mConducted emissions with integrated EMC filter environment 1 category C2 EN/IEC 61800-3 2...12 kHz shielded motor cable <5 mConducted emissions with integrated EMC filter environment 1 category C2 EN/IEC 61800-3 2, 4 and 16 kHz shielded motor cable <10 mConducted emissions with additional EMC filter environment 1 category C1 EN/IEC 61800-3 4...12 kHz shielded motor cable <20 mConducted emissions with additional EMC filter environment 1 category C2 EN/IEC 61800-3 4...12 kHz shielded motor cable <50 mConducted emissions with additional EMC filter environment 2 category C3 EN/IEC 61800-3 4...12 kHz shielded motor cable <50 m | |
| product certifications | GOSTC-TickNOMCSAUL | |
| vibration resistance | 1 gn 13…200 Hz)EN/IEC 60068-2-61.5 mm peak to peak 3…13 Hz) - drive unmounted on symmetrical DIN rail - EN/IEC 60068-2-6 | |
| shock resistance | 15 gn 11 ms EN/IEC 60068-2-27 | |
| relative humidity | 5…95 % without condensation IEC 60068-2-35…95 % without dripping water IEC 60068-2-3 | |
| ambient air temperature for storage | -25…70 °C | |
| ambient air temperature for operation | -10…40 °C protective cover from the top of the drive removed40…60 °C with current derating 2.2 % per °C | |
| operating altitude | > 1000...2000 m with current derating 1 % per 100 m<= 1000 m without |
| Jätkusuutliku pakkumise olek | Green Premium toode | |
|---|---|---|
| REACh-määrus | ||
| ELi RoHS direktiiv | Ennetav vastavus (toode ei jää EL-i RoHS seadustega määratud piiridesse) ELi RoHS deklaratsioon | |
| Elavhõbedavaba | Jah | |
| RoHS eranditeave | ||
| Hiina EoHS regulatsioon | ||
| Keskkonnaalane avaldus | ||
| Ringlusprofiil | ||
| WEEE | Tootest tuleb Euroopa Liidu turgudel vabaneda vastavuses erijäätmeseadustele ning see ei tohi sattuda olmeprügi sekka. |
- Be the first to review this product
Write Your Own Review
Kontaktid
-
Aadress
Kadaka tee 50-10b, 12915 Tallinn, Estonia -
Telefoni number
+3725089251 -
E-Post
info@elektrikaubad.ee
© Winvol OÜ, 2020. Kõik õigused kaitstudreg. nr: 12750864, VAT: EE101810186
Tööaeg
Mon - Fri / 9:00AM - 6:00PM
Mon - Fri / 9:00AM - 6:00PM
